Remove the old valve cover gasket from around the inner edge of the valve cover using the flat-head screwdriver and the razor blade. Place the bolts in a clean, dry place, until you are done with this project. Remove the valve cover from the engine, using the ratchet set. Allow the engine to completely cool off before you proceed with this project. Park the Honda on a flat level surface and open the hood.
#HOW TO INSTALL SPARK PLUG TUBE SEALS HONDA HOW TO#
How to Replace a Valve Cover Gasket on a Honda Fill the car with oil and allow it to run idle. Reconnect the clam for the PCV now and reconnect the battery terminals. Reconnect the bolts to the fuel injector bracket. Be careful not to over tighten as this may result in the gasket not fitting in a sitting area appropriately. Replace the valve cover and tighten the bolts. Place the new gasket into the seating area. Remove the valve cover in the old gasket.Ĭlean the seating area with automotive engine cleaner. Move aside and remove the remaining valve cover bolts.ĭisconnect ignition coil wires and move the wiring aside. Make sure that you park the car in an area that allows for maintenance to be performed on your CRV.ĭisconnect the battery terminals and the clamp from the PCV valve.ĭisconnect the bolts from the fuel injector bracket. How to Replace Valve Cover Gasket in a Honda CR-VĪllow the engine to cool. Your maintenance is now complete and you can get back on the road. Replace the PCV Valve and the hose, the throttle cable, cruise control actuator, breather hose and air cleaner assembly.Īdd oil to the vehicle and allow it to run idle. Replace the ignition coil wires and harness, EGR connectors and the VTEC solenoid switch connector and harness. Replace and tighten the cylinder head bolts in sequence until all nine bolts have been tightened. Replace the new valve cover gasket and the valve cover.
Remove the old gasket and clean the cover with automotive engine cleaner. Remove cylinder head bolts and remove the cover. Remove the EGR (exhaust gas recirculation) connectors and the VTEC (variable valve timing and lift electronic control) solenoid switch connector and harness. Remove the throttle cable, cruise control actuator, breather hose and air cleaner assembly. Remove the PCV Valve and the hose by firmly gripping it.
0 kommentar(er)
